Volume change of Selected Staves.
I want to change the volume of a selected stave line relative to the others in a piece of music down loaded by Musician.
I choose Staff controls from the view command, click the little blue arrow only in Staff Selection and while the music is playing move the Volume slider. This however changers the volume of all the staves not the specific one highlighted. This is as written in instructions, but is not working. What am I doing wrong? Thanks. |
Re: Volume change of Selected Staves.
Hi, Impulse:
To permanently change the volume of one or more staves, you can use the Staff Setup to enter an initial numeric value for each staff. Alternatively, for changes within the music, you can click on the GraphOverNotes(TM) tab, make sure the VOL icon is selected and use the tools in the toolbar to draw volume lines or curves or erase data. The "96" icon will let you input a numeric value for a range you've previously selected. The volume slider and temp scroller are intended for temporary changes, for example, when working on a piece and wanting to try out an effect without any permanent changes. I've frankly never even looked at the volume slider before (in, what?, 15 years of using Notation Software), so I'm not sure of what it's supposed to do. I'll do some checking on it and see what's happening. But, to change volume on a more permanent basis, use the Staff Setup or GraphOverNotes(TM) methods. David |
Re: Volume change of Selected Staves.
Hi,
Quote:
We decided against actually increasing any volumes higher than the "set" volume so as to avoid blowing out ears or speakers :) ttfn, Sherry |
All times are GMT. The time now is 02:35 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Notation Software Germany GmbH www.notation.com/Imprint.php