|
|
Questions or problems Have a question or problem about something you can't find in the Help/Users Guide? Ask it here! |
|
Thread Tools | Display Modes |
#2
|
|||
|
|||
Re: Measure Numbers for Repeat Staff Endings
Yikes, Sorry about the size of the image!
Following up on the above, I now cannot change the numbers of bars per line in the Layout section. I keep getting a red message in the bottom RH corner "Command is unexpectedly complex". This happens even if I try to reset the layout back to default (Def). Tried closing the file and restarting the program, even rebooting but still the same message. I hope you can help. Kind regards, Iain |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Eliminating Time Signature from Upbeat Measure | fr4209fr@yahoo.com | Questions or problems | 1 | 01-13-2010 10:14 PM |
Set Staff Control enabled as default | tony4519 | Questions or problems | 2 | 09-06-2009 07:47 PM |
Position of measure numbers in relation to staff | Andrew Schwartz (andys) | Questions or problems | 2 | 02-26-2009 02:57 PM |